6 Jan. 2011 8:00am. Accepted delivery of my new Inglis gas dryer from the Best Buy located at 3820 S Maryland Pkwy Las Vegas, NV 89119. Delivery guy #1 removed old dryer and allowed me to clean the area. Delivery guy #2 brought the new dryer in. I watch the Delivery guy #1 hook up the gas line and exhaust vent hose. After he was done he pushed the dryer against the wall and crushed the vent hose. I told him that and he said "it is ok". I told him no its not the hose should not be crushed like that. Reluctantly he moves the dryer forward and fixes the vent hose. I also ask him why did you fully extend the vent hose? The Vent Hose had two 90 degree turns. I tell him the more twist and turns you have in the vent hose the less efficient it will be and increases the chance of a lint fire. What he should do is fully extend the hose and cut off the excess so that it is short and straight as possible. He gives me the same reply "it is ok". I get tired of trying to explain common sense installation procedures and let them leave. Typical "I don't care it;s not my problem" mentality like most people have nowadays. After they leave I go behind the dryer and push all the excess vent hose length back into itself and straighten the hose so that it is as short and straight as possible, which is what the delivery guy should have done. I plan on installing a Rigid Metal Vent to replace the Flexible Metal Vent. Rigid Metal Vents are recommended for best drying performance and to reduce the risk of lint fires. I am very disappointed with this installation. Next time I will spend my money elsewhere.